Questions tagged [temperature-drift]
The temperature-drift tag has no usage guidance.
10
questions
2
votes
4
answers
919
views
PT1000 drifts more than 100°C
I'm using a PT1000 and MAX31865 to measure the temperature inside a machine.
Electronics (MAX31865 and MCU) are inside an isolated box. The PT1000 is outside and connected in two wire configuration (...
- 378
0
votes
3
answers
655
views
How "Zero" is this supposedly Zero-TCR resistor? And how much better is it than this other one?
I found a resistor at Digikey, and the TCR was quoted as being 0.0ppm/°C, and I had to check the datasheet just to refute my suspicion that it was a data entry error, and it looks real, but just how ...
- 2,892
2
votes
2
answers
82
views
Low frequency asymmetrical led blinking circuit, lacking thermal stability
I'm trying to use a NE555D to achieve a 500ms on, 1500ms off, duty cycle. The exact timing is not that important(+-20%).
But my problem is that when the temperature changes it greatly effects the ...
- 33
0
votes
0
answers
45
views
Help in understanding poor temperature stability of an induction proximity sensor circuit
I have been experimenting with a circuit for an induction proximity sensor, that was reverse engineered in the following post:
Help with reverse engineering a small PCB
I have built the circuit, but ...
- 1
2
votes
1
answer
169
views
Current source temperature stability
I want to implement an interesting current source topology that I came across recently (picture below). It shows very good performance in simulation and the only thing I am concerned of is its ...
- 151
0
votes
1
answer
205
views
How to compensate for shunt resistor thermal drift? [closed]
I'm working on a electronic load and below schematic is the simplified version of it.
simulate this circuit – Schematic created using CircuitLab
The problem is the thermal drift in resistors ...
- 2,396
1
vote
1
answer
921
views
Voltage reference drift in ppm/°C to V/°C
How does one convert drift in ppm/°C to V/°C?
Assume a 5 V voltage reference has an output voltage drift of 12 ppm/°C.
What is the output voltage drift in volts for a target temperature of 85°C?
- 113
0
votes
0
answers
185
views
IGBT Temperature Drift: How to Achive Stability?
I remember the BJT transistor circuits are designed to compensate for the fact that the parameters of the transistor change with the temperature. I could not find similar ready-to-use solutions for ...
- 191
1
vote
1
answer
269
views
Max31855k - fluctuation and drift
I'm using a b 31855k breakout board (a chinese one at that) with the olimex A20 and a K-type thermocouple (which works OK on another device with the 31855k).
The problem is, that the thermocouple temp ...
- 21
1
vote
1
answer
194
views
Temperature drift on volatge divider built with resistors from the same series
I am in the process of designing a data acquisition device that will be used outdoors, with temperature swings of around 30 degrees.
For this i need to scale the input to a voltage suitable to the adc ...
- 915