Questions tagged [motor]
An electrical actuator that converts electrical energy into rotational motion or sustained linear motion (linear motor). If the specific type of motor is known, it is helpful to use or add a more specific tag, such as dc-motor, brushless-dc motor or induction-motor.
3,520
questions
0
votes
0
answers
7
views
I am running 10Kva alternator from 10hp motor need to ask some explanation
So here is my equipment
I am using solar controller to run motor which runs alternator which generates electricity and which is used for my house 🏡 requirements.
10 Kva single phase 220v 50hz @...
1
vote
1
answer
25
views
Wiring a new fan motor to my home air conditioner
My original house A/C fan (condenser) motor stopped working. It was an F48SJ6MA6. They're no longer made. I purchased an OCB1026A. They come with different combinations of wires.
The original motor ...
0
votes
0
answers
13
views
Can I use a large ESC controller with a mini BLDC motor? [closed]
I bought a HappyModel SE0802 19000KV Brushless motor for a project. I have a 30A 2S-4S BLHeli ESC controller. Is it possible to run the motor with this ESC controller?
2
votes
0
answers
47
views
Why does my PMSM motor stop unexpectedly?
I have two PMSM motors, motor1 with 8 pole pairs and motor2 with 17 pole pairs
I use a gyroscope to measure speed;
I use PID controller1 and PID controller2 set two velocity for motor1 and motor2;
I ...
1
vote
2
answers
64
views
Turning on a 600W AC motor (PCB, circuit design)
I am looking for a bit of advice (or corrections). I need to turn on a 600W AC motor (220V 50Hz), just ON-OFF control.
I plan to use the following circuit which AFAIK it should work well for resistive ...
2
votes
1
answer
66
views
I'm trying to wire this motor I have, but I'm not sure how to read this diagram
This motor is 110V or 220V. I'm trying to wire it up for 110 but I'm not 100% sure how. Is low std 110V and high 220V?
I believe I need to connect 1,3,8 to hot and 2,4,5 to neutral and ground to the ...
0
votes
1
answer
27
views
Slew drive 12 volt motor with 7 wires
I have just acquired a slew drive for my solar tracker but it has 7 wires…
3 thick and 4 thin. The thick are positive negative and earth and the other 4 thin wires are for a controller. I don’t know ...
0
votes
0
answers
37
views
How to properly limit motor overspeed during regenerative torque
I are facing a potential issue and need some help with possible solutions.
How to stop motor from over-speeding during a regenerative load, once maximum torque current limit is hit and the system's ...
1
vote
1
answer
91
views
'Strange' behaviour due to DC motor
TLD: How do I minimise noise / electrical disruptions created by a DC motor?
Situation
I would like to control a DC motor through DMX512. Therefore I connected a Max485 chip to an Arduino to receive ...
0
votes
1
answer
36
views
Negative active power readings?
I am using a Fluke 434 Power Quality Analyser on a balanced load, on the supply side of a CNC machine. I am acquiring active, reactive & apparent power, see graph below.
Would I be right to say ...
0
votes
0
answers
43
views
Relay controlling DC motor welding shut
I am controlling a fairly large DC motor using a relay. The motor draws approximately 7A at 36V. I am controlling it with a relay rated at 110VDC, 50A. To protect against back-EMF, I placed a ...
0
votes
1
answer
32
views
Motor Direction standard nomenclature confusion
Does anyone know what is the standard nomenclature used when talking about motor direction?
I see in some motor manuals the following are generally used:
Forward, Reverse direction
Clockwise, Counter-...
0
votes
2
answers
102
views
Is it possible to use just two SPDT relays to control this AC motor?
I purchased an inexpensive electric hoist off Amazon with the intention of partially replacing its control circuits so that it can controlled via ESPhome.
There are only 2 buttons on the control box. ...
0
votes
0
answers
40
views
AC Motor Control with TRIAC
I want to drive an AC motor using a TRIAC. I am new to this topic. I built this circuit and found that it is not working. What could be the reasons for this?
1
vote
1
answer
62
views
Why fan motor doesn't spin freely after power is applied? [closed]
My Breville toaster oven convection fan stopped working. I took it apart to access the motor and it spins perfectly with no power. Zero resistance, silent, and takes a good 10 seconds to slow to a ...