All Questions
Tagged with probe calibration
5
questions
2
votes
0
answers
205
views
Tektronix P6015 Replacement Potentiometer Considerations
I’ve acquired (saved from the landfill) an old Tektronix high voltage probe, model P6015. The probe body and cable are in decent condition, but I discovered two damaged potentiometers in the ...
1
vote
1
answer
163
views
EMC-BCI. Coil injection and probe were calibrated at 100 ohm
As the title says my coil injection and coil probe were calibrated into 100 ohm loop line Impedance and it resulted an insertion loss (dB) for the coil injection.
and transfer impedance (dBΩ) coil ...
1
vote
1
answer
459
views
Why is the calibration signal's amplitude of my oscilloscope 10 times higher than stated?
I'm trying to calibrate my HAMEG HM507 oscilloscope.
The manual says that the calibration signal is 0.2Vpp. With the attentuation of the probe set to x10, volts/division set to 5mV/cm, time/division ...
1
vote
1
answer
420
views
Analogue oscilloscope probe selection
Recently, I have bought an oscilloscope with model Panasonic VP-5512A
Panasonic VP-5512A 100 MHz 2CH+1/2+1/2 Dual Timebase
It is an analog oscilloscope.
...
6
votes
2
answers
1k
views
How often should I have to set oscilloscope probe's capacitance?
I got a new Owon SDS7102 oscilloscope and I'm using the included oscilloscope probes with it.
The manual says that the proper calibration procedure is to let the oscilloscope work at constant ...