Top new questions this week:
|
This concerns a USB A socket on a PCB.
Is there a standard or preferred orientation of the polarization tab, either up or down?
The picture shows one with tab towards the top
|
I’ve designed a fan control circuit using an N-channel MOSFET (STN3NF06L.) The fan operates at 12V, and I’ve isolated the 12V side from the 3.3V microcontroller side using an optocoupler (ACPL-W314-...
|
The question asks; "P14.25 Analyze each of the ideal-op-amp circuits shown in Figure P14.25 to find expressions for 𝑖𝑜. The top part is the question, the bottom is the solution from the ...
|
I want my code to be able to determine the direction of motion for the LIS2DE12 accelerometer. I did a test where I had the accelerometer on a breadboard (connected to the STM32) and logged the values ...
|
Just an example - STM32F722 has a few versions, but I'm talking about just the variance between two numbers: RET6 vs RET7. The former has a max operating temp of 85C, whereas the latter says 105C. ...
|
3 V signal (PWR-ENABLE) be enough to turn on this circuit?
The collector of Q3 will be at 11 V before switching is to occur.
Q3 Data sheet
Q1 Data sheet
|
The question asks: "Exercise 14.5 Assume an ideal op amp and use the summing-point constraint to find an expression for the output current io in the circuit of Figure 14.14. Also find the input ...
|
Greatest hits from previous weeks:
|
I've come across multiple mentions of switches described as 1NO1NC.
They often described as having 2 options: ON/(OFF) and (ON)/OFF and from what I gather they have 3 terminals for wires: a NO ...
|
What is the difference between cascode amplifier configuration and cascade amplifier configuration?
|
Like most computer hobbyists and programmers, I've amassed boxes of USB cables to connect USB, Micro-USB, and Mini-USB to chargers, computers, and gadgets. These cables are a mix of phone charger ...
|
I am relatively new here and I am confused as to the difference between Vrms and Vm. I would be obliged if someone can explain. (This in relation to 3-phase circuits would be even better)
My shot at ...
|
I have a cell phone battery that has the following written on one side:
3.7 V 1000mAh
Limited charge voltage: 4.2 volts
I understand that the first line means, that the battery will always give 3....
|
What is the difference between a latch and a flip-flop?
What I am thinking is that a latch is equivalent to a flip-flop since it is used to store bits and is also equivalent to a register which is ...
|
I know that electric vehicles have different performances depending on battery and motor, but it's not clear how electrical and mechanical units are related.
Will a 100V motor raise against slopes ...
|
Can you answer these questions?
|
I am relearning MOSFETs, but more importantly I would like to focus on building some basic circuits and learning practicality over theory. I have a BSEE but haven't spent much time outside of class on ...
|
I'm using RC5 encoding for my project.
I'm sending signals using RC5 Protocol. The transmitter is sending the signals correctly.
But on the receiver node, when I decode the signals, Library is unable ...
|
I'm using a circuit to charge and discharge a capactior at different rates, where the capacitor has a capacitance of 10uF. I have tested the circuit in a breadboard and it worked well with an ...
|