-
Low-frequency pulse-jitter measurement with the uGMRT I : PSR J0437$-$4715
Authors:
Tomonosuke Kikunaga,
Shinnosuke Hisano,
Neelam Dhanda Batra,
Shantanu Desai,
Bhal Chandra Joshi,
Manjari Bagchi,
T. Prabu,
Keitaro Takahashi,
Swetha Arumugam,
Adarsh Bathula,
Subhajit Dandapat,
Debabrata Deb,
Churchil Dwivedi,
Yashwant Gupta,
Shebin Jose Jacob,
Fazal Kareem,
Nobleson K,
Pragna Mamidipaka,
Avinash Kumar Paladi,
Arul Pandian B,
Prerna Rana,
Jaikhomba Singha,
Aman Srivastava,
Mayuresh Surnis,
Pratik Tarafdar
Abstract:
High-precision pulsar timing observations are limited in their accuracy by the jitter noise that appears in the arrival time of pulses. Therefore, it is important to systematically characterise the amplitude of the jitter noise and its variation with frequency. In this paper, we provide jitter measurements from low-frequency wideband observations of PSR J0437$-$4715 using data obtained as part of…
▽ More
High-precision pulsar timing observations are limited in their accuracy by the jitter noise that appears in the arrival time of pulses. Therefore, it is important to systematically characterise the amplitude of the jitter noise and its variation with frequency. In this paper, we provide jitter measurements from low-frequency wideband observations of PSR J0437$-$4715 using data obtained as part of the Indian Pulsar Timing Array experiment. We were able to detect jitter in both the 300 - 500 MHz and 1260 - 1460 MHz observations of the upgraded Giant Metrewave Radio Telescope (uGMRT). The former is the first jitter measurement for this pulsar below 700 MHz, and the latter is in good agreement with results from previous studies. In addition, at 300 - 500 MHz, we investigated the frequency dependence of the jitter by calculating the jitter for each sub-banded arrival time of pulses. We found that the jitter amplitude increases with frequency. This trend is opposite as compared to previous studies, indicating that there is a turnover at intermediate frequencies. It will be possible to investigate this in more detail with uGMRT observations at 550 - 750 MHz and future high sensitive wideband observations from next generation telescopes, such as the Square Kilometre Array. We also explored the effect of jitter on the high precision dispersion measure (DM) measurements derived from short duration observations. We find that even though the DM precision will be better at lower frequencies due to the smaller amplitude of jitter noise, it will limit the DM precision for high signal-to-noise observations, which are of short durations. This limitation can be overcome by integrating for a long enough duration optimised for a given pulsar.
△ Less
Submitted 18 April, 2024; v1 submitted 4 December, 2023;
originally announced December 2023.
-
Using low-frequency scatter-broadening measurements for precision estimates of dispersion measures
Authors:
Jaikhomba Singha,
Bhal Chandra Joshi,
M. A. Krishnakumar,
Fazal Kareem,
Adarsh Bathula,
Churchil Dwivedi,
Shebin Jose Jacob,
Shantanu Desai,
Pratik Tarafdar,
P. Arumugam,
Swetha Arumugam,
Manjari Bagchi,
Neelam Dhanda Batra,
Subhajit Dandapat,
Debabrata Deb,
Jyotijwal Debnath,
A Gopakumar,
Yashwant Gupta,
Shinnosuke Hisano,
Ryo Kato,
Tomonosuke Kikunaga,
Piyush Marmat,
K. Nobleson,
Avinash K. Paladi,
Arul Pandian B.
, et al. (6 additional authors not shown)
Abstract:
A pulsar's pulse profile gets broadened at low frequencies due to dispersion along the line of sight or due to multi-path propagation. The dynamic nature of the interstellar medium makes both of these effects time-dependent and introduces slowly varying time delays in the measured times-of-arrival similar to those introduced by passing gravitational waves. In this article, we present a new method…
▽ More
A pulsar's pulse profile gets broadened at low frequencies due to dispersion along the line of sight or due to multi-path propagation. The dynamic nature of the interstellar medium makes both of these effects time-dependent and introduces slowly varying time delays in the measured times-of-arrival similar to those introduced by passing gravitational waves. In this article, we present a new method to correct for such delays by obtaining unbiased dispersion measure (DM) measurements by using low-frequency estimates of the scattering parameters. We evaluate this method by comparing the obtained DM estimates with those, where scatter-broadening is ignored using simulated data. A bias is seen in the estimated DMs for simulated data with pulse-broadening with a larger variability for a data set with a variable frequency scaling index, $α$, as compared to that assuming a Kolmogorov turbulence. Application of the proposed method removes this bias robustly for data with band averaged signal-to-noise ratio larger than 100. We report, for the first time, the measurements of the scatter-broadening time and $α$ from analysis of PSR J1643$-$1224, observed with upgraded Giant Metrewave Radio Telescope as part of the Indian Pulsar Timing Array experiment. These scattering parameters were found to vary with epoch and $α$ was different from that expected for Kolmogorov turbulence. Finally, we present the DM time-series after application of the new technique to PSR J1643$-$1224.
△ Less
Submitted 28 September, 2023;
originally announced September 2023.
-
Galaxy Rotation Curve Measurements with Low Cost 21 cm Radio Telescope
Authors:
Arul Pandian B,
Ganesh L,
Inbanathan S. S. R,
Ragavendra K B,
Somashekar R,
Prabu T
Abstract:
Probing the Universe with atomic hydrogen 21 cm emission is a fascinating and challenging work in astronomy. Radio telescopes play a vital role in detecting and imaging these faint signals. Powerful radio telescopes are complex to construct and operate. We have built a simple, low-cost 21 cm radio telescope primarily for educational training purposes. The design uses a custom horn antenna, ready-t…
▽ More
Probing the Universe with atomic hydrogen 21 cm emission is a fascinating and challenging work in astronomy. Radio telescopes play a vital role in detecting and imaging these faint signals. Powerful radio telescopes are complex to construct and operate. We have built a simple, low-cost 21 cm radio telescope primarily for educational training purposes. The design uses a custom horn antenna, ready-to-use radio-frequency components, and a software-defined radio module. The telescope operates efficiently from a rooftop in a city environment. Using this telescope, we have conducted observations and successfully detected the 21 cm line emissions from the different directions of our galactic plane. Based on the Doppler-shift observed in these measurements, we have successfully derived the Galactic rotation velocity (rotation curve) in those directions. The paper presents the details of the telescope construction, 21 cm observation, and the Galactic rotation curve derivation.
△ Less
Submitted 22 February, 2022;
originally announced February 2022.
-
Stereo Acoustic Perception based on Real Time Video Acquisition for Navigational Assistance
Authors:
Supreeth K. Rao,
Arpitha Prasad B.,
Anushree R. Shetty,
Chinmai,
R. Bhakthavathsalam,
Rajeshwari Hegde
Abstract:
A smart navigation system (an Electronic Travel Aid) based on an object detection mechanism has been designed to detect the presence of obstacles that immediately impede the path, by means of real time video processing. The algorithm can be used for any general purpose navigational aid. This paper is discussed, keeping in mind the navigation of the visually impaired, and is not limited to the same…
▽ More
A smart navigation system (an Electronic Travel Aid) based on an object detection mechanism has been designed to detect the presence of obstacles that immediately impede the path, by means of real time video processing. The algorithm can be used for any general purpose navigational aid. This paper is discussed, keeping in mind the navigation of the visually impaired, and is not limited to the same. A video camera feeds images of the surroundings to a Da- Vinci Digital Media Processor, DM642, which works on the video, frame by frame. The processor carries out image processing techniques whose result contains information about the object in terms of image pixels. The algorithm aims to select the object which, among all others, poses maximum threat to the navigation. A database containing a total of three sounds is constructed. Hence, each image translates to a beep, where every beep informs the navigator of the obstacles directly in front of him. This paper implements an algorithm that is more efficient as compared to its predecessors.
△ Less
Submitted 9 August, 2012;
originally announced August 2012.
